Install
Requirements:
- Chrome Web Browser
- USB-C Data Cable
Release notes and discussion about firmware updates can be found on the PedalPCB forum.
Instructions:
- Plug in Q-Tune to your computer using a USB-C data cable and then click the Connect to device button.
- If your computer recognizes the Q-Tune, it will show up as an option starting with USB JTAG/serial....
- Select that option and click the Connect button.
- Click the Install Q-Tune option.
- DO NOT select the Erase device option unless you want to erase all of your user settings.
- Click the Next button and then confirm by clicking the Install button.
- Wait for the installer to finish. Once it's done you can unplug the USB-C cable and put Q-Tune to use on your pedalboard!
First install of v5.0 or newer
Q-Tune v5.0 added support for two different boards. The first time you install v5.0 or newer, or any time you do a factory reset, your tuner shows a setup screen with two options: Solderless (the standard Q-Tune) and Thru-Hole (the Q-Tune Solder Kit). You only choose once.
Choose carefully. The GPIOs that drive the relays and switches are reversed between the two boards. If you pick the wrong one, bypass and switching won't work correctly. Pick Solderless for the standard kit, or Thru-Hole if you soldered the board together from loose components.
Not Allowed
Flashing is only supported from the local host or from a secure web site.
Browser Not Supported